Filter
Top Products
ADW-4302v2 User Guide
Data - VPN-Auto Policy Screen
General
Policy Name
Enter a unique name to identify this policy. This name is not
supplied to the remote VPN endpoint. It is used only to help
you manage the policies.
Remote VPN
Endpoint
If the remote endpoint has a dynamic IP address, select
"Dynamic IP address". No "Address Data" input is required.
Otherwise, select the desired option (IP address or Domain
Name) and enter the address of the remote VPN endpoint
you wish to connect to.
Note: The remote VPN endpoint must have this VPN Gate-
way's address entered as its "Remote VPN Endpoint".
NetBIOS Enable
Check this if you wish NETBIOS traffic to be forwarded over
the VPN tunnel. The NETBIOS protocol is used by Microsoft
Networking.
Local LAN
Local LAN
This identifies which PCs on your LAN are covered by this
policy. For each selection, data must be provided as follows:
• Single address
Enter an IP address in the "IP address" field. Typically,
this setting is used when you wish to make a single
Server on your LAN available to remote users.
• Subnet address
Enter an IP address in the "IP address" field, and the de-
sired network mask in the "Subnet Mask" field.
The remote VPN endpoint must have these IP addresses
entered as its "Remote" addresses.
Remote LAN
Remote LAN
This identifies which PCs on the remote LAN are covered by
this policy. For each selection, data must be provided as
follows:
• Single PC - no subnet
Select this option if there is no LAN (only a single PC) at
the remote endpoint. If this option is selected, no addi-
tional data is required.
• Single address
Enter an IP address in the "IP address" field. This must
be an address on the remote LAN. Typically, this setting
is used when you wish to access a server on the remote
LAN.
• Subnet address
Enter an IP address in the "IP address" field, and the de-
sired network mask in the "Subnet Mask" field.
The remote VPN endpoint must have these IP addresses
entered as its "Local" addresses.
80