Filter
Top Products
6
Chapter 3
Initial Configuration
3.1 Default Settings
The communication interfaces of IKVM-1000 are all based on TCP/IP. It comes
with the default settings as below.
Parameter Value
IP auto configuration
DHCP
IP-Address 192.168.1.1 (disabled)
Net-mask 255.255.255.0
Default-Gateway none
Super user name super
Super user password pass
Note: although there is a pre-configured IP address in IKVM-1000, it is disabled by
default. To make the IP effective, you must use psetup.exe to locate the IKVM-
1000 and change the “IP auto configuration” from “DHCP” to “None”. Please refer
to next subsection for detailed information.
3.2 Configuration via Setup Utility
By default, the IKVM-1000 will obtain its IP address from a DHCP server in the
network. If a DHCP server is found, it may provide a valid IP address, gateway
address and net mask. Before you connect IKVM-1000 to your local network,
please make sure the corresponding configuration of your DHCP server is com-
pleted. It is recommended to reserve a fixed IP assignment to the MAC address of
the IKVM-1000. You can find the MAC address labeled on the bottom side of the
metal housing.
If this initial configuration does not meet your local requirements, use the setup tool
to adjust the values to your needs. The setup tool can be found on the CD-ROM
delivered with this package. You can follow the procedure described below.
1. Connect the IKVM-1000 to the same network as your administrative PC, or you
can use an USB cable (type A to type B) to connect administrative PC and
3