Filter
Top Products
- 36 -
Dynamic Address Counts
Number of MAC addresses automatically learned by the current switch.
Static Address Counts
Number of MAC addresses manually added to the current switch.
To add a static address
1. Click the combo box and select a port, then the MAC address table of the port
appears.
2. Fill in configuration value (VLAN ID, MAC address), then click “<<Add” button
(Note that ports on the switch are all default to VLAN 1).
NOTE: The ports of Port Aggregation Group can not be added in Static Address
table.
To remove a static address
1. Click the static address in the MAC address table of the port.
2. Click “Remove>>” button to remove it from MAC address table.
4.15 Mirror
Port mirror is used to mirror traffic from source port to a target port for analysis. Only 2
ports can be monitored (mirrored) simultaneously to 1 sniffer port (target port). (Note that
the target port must be in the same VLAN as the source port).
1. Click “Active” radio button to activate port mirror.
2. Select ‘Monitored Ports’ (up to 2 ports).
3. Click ‘Sniffer Port’ combo box and select a sniffer port (target port) and click “Apply”
to apply.
4. This figure describes port 2 and port 3 will be mirrored to port 11.