Filter
Top Products
- 4 -
Chapter 2 HARDWARE INSTALLATION
This section describes the hardware features and installation of these Switches. For
easier management and control of the switch, familiarize yourself with its display
indicators, and ports. Front panel illustrations in this chapter display the unit LED
indicators. Before connecting any network device to the switch, read this chapter
carefully.
Furthermore, there are six choices of different modules for expansion:
l WGSW-D1GT: 10/100/1000Base-T module
l WGSW-D1SX: 1000Base-SX module
l WGSW-D1LX: 1000Base-LX module
l WGSW-D1SC: 100Base-FX module (SC interface)
l WGSW-D1ST: 100Base-FX module (ST interface)
l WGSW-D1S15: 100Base-FX module (SC interface)
2.1 Front Panel
The unit front panel provides a simple interface monitoring the switch.
100MbpsLNKACT10MbpsLNKACT FDXCOL
PWR
LNK/ACT
2526
LNK/
ACT
FDX/
COL
LNK/
ACT
FDX/
COL
MASTER
STATUS
24-port Stackable Ethernet Switch
123456789101112
131415161718192021222324
LNK
INOUT
STACK
Switch ID
RESET
1123456789101112
131415161718192021222324
WGSW-2403 Switch front panel
LED indicators
PWR Green On: Power on
MASTER Green When this LED steady green, it means the device acts
competent leading role (Master), an indispensable essential for
system administrator to control and monitor whole system.
At the time one member of the cluster disconnected or new
member joined, the LED blinks. Soon, one and only one master
will be raised. You can refer to “SWITCH ID” section below for
relative information.
STATUS Flashing
Green
Run Time Error occurs
Off No Connection on the port
Green The port is connected at 100Mbps
Flashing
Green
There is traffic transverses the port
Amber The port is connected at 10Mbps
10/100
Mbps
ports
LNK/ACT
Flashing
Amber
There is traffic transverses the port