Filter
Top Products
Hardware Interface = 25
LTC Time Code Input
A LTC time code input is provided on the LTC IN BNC connector. This input may be selected
by means of the On-Screen user interface and recorded as a time code reference. The LTC
input provides a >10k ohm termination.
LTC Time Code Output
An LTC time code output is provided on the LTC OUT BNC connector. It may be selected by
means of the On-Screen user interface to output time code from any of the three video
channels during playback. The LTC output has a low source impedance of <5 ohms.
Keyboard
Attach the alphanumeric keyboard to the purple 5-pin KEYBD connector to control the server
and manage clips with the On-Screen graphic user interface. Note that the server will only
recognize the keyboard if it is attached before power up.
Mouse
A two-button scroll mouse is provided with the Image Server. Plug the mouse into the green
5-pin MOUSE port. Note that the server will only recognize the mouse if it is attached before
power up.
Monitor
A VESA-compliant computer monitor may be connected to the 15-pin VGA video port. The
Image Server resolution is fixed at 1024 x 768 pixels, with a refresh rate of 72 Hz. This is
best-viewed on 17-inch or larger monitors. 360 Systems does not provide monitors for the
server. Note: Do not use older monitors that do not state they are VESA compliant.
Serial Port
The system board serial port is not used. Make no connection.
USB Ports
The system board USB ports are not used. Make no connection.
Power
An IEC mains socket is provided on the rear panel for power input. The Image Server will
accept worldwide power sources in the range of 100-240 volts AC, 50-60 Hz. The server is
shipped with a power cord appropriate for the region in which it is sold. Replace the power
cord only with one of the same type and rating.