Filter
Top Products
User’s Guide • 2–19
Chapter 2 • Detailed Setup
1
2
3
Figure 2-14
Power receptacle (1), AC POWER switch (2), and circuit
breaker reset switch (3)
To power up the projector:
1. Plug the power cord into the Desktop Projector's power
receptacle at the rear of the unit.
CAUTION! Plug the AC power cord into the Desktop
Projector BEFORE connecting it to an electrical outlet. If you
plug the power cord into the wall first, you might damage the
projector.
2. Connect the power cord to a properly-grounded wall outlet or
surge protector.
3. Move the AC POWER switch to the ON position. The lamp
comes on and the projector's fan begins to run. If you do not
hear the fan, refer to Chapter 5.
4. Turn on your monitor and computer. To raise or lower the
projected image, tilt the mirror assembly to the appropriate
angle.
☞