Filter
Top Products
Batteries
116 PT2000™ & TopGun™
Alkaline Batteries
The PSC PT2000 or TopGun comes with three alkaline batteries
installed. To replace the alkaline batteries, complete the following steps:
1. Detach the elastic hand strap on the back of the portable by
pulling its hook out of its holder near the base (refer to
Figure C-1
on
page 100).
2. Press on the arrow symbol on the battery-compartment cover and
push the cover in the direction indicated by the arrow.
3. Pull the end of the plastic ribbon sticking out of the battery
compartment toward the batteries until they pop out.
4. Set the two switches inside of the battery compartment for the
type of batteries being used.
Figure E-1: Base of the battery compartment
Refer to the diagram inside the battery compartment which
indicates the positions for alkaline (
ALK) and nickel-
cadmium (
NiCd) batteries (refer to Figure E-1).
Make sure Switch 2 is in the ALK position. If necessary, use a
pen or a small screwdriver to slide the switch to that position.
ALK NI-Cd
ON
40
K
12
Close-up shows
switch 1 in ALK
position and
switch 2 in NI-Cd
position
PT2000.book Page 116 Thursday, February 26, 2004 9:34 AM