Q-Logic 3000 Network Card User Manual


 
NE0154601-00 A B-1
B Solaris Driver, nxflash
Utility, and Firmware
Installation
QLogic Adapter Driver Installation
To extract and install the Solaris QLogic adapter driver using the
Sol<ver>_ntxn_1.7.tar.gz package:
1. Unzip the driver package file using the
gunzip command.
2. Untar the driver package file using the
tar xfp command.
3. Remove any previous driver version.
a. Type one of the following commands:
For a 64-bit operating system (OS), type:
pkgchk –l –p /kernel/drv/amd64/ntxn
For a 32-bit OS, type:
pkgchk –l –p /kernel/drv/ntxn
b. For both OSes, type the following commands:
pkgchk –l NTXNxge
pkgrm NTXNxge
4. Install the new driver, pointing to the directory where /NTXNxge is located.
For example:
pkgadd –d /tmp/Sol<ver>_ntxn_1.7/Solaris
5. Type the following to make sure that the package is installed:
pkginfo –l NTXNxge