Q-Logic 5000 Switch User Manual


 
14 – Command Reference
Group
59183-02 A 14-33
A
Notes Primary and secondary secrets are not included in a switch configuration backup.
Therefore, after restoring a switch configuration, you must re-enter the primary
and secondary secrets. Otherwise, the switch will isolate because of an
authentication failure.
Refer to the “Securityset” command on page 14-67 for information about
managing groups in security sets.
Examples The following is an example of the Group Add command:
SANbox #> admin start
SANbox (admin) #> security edit
SANbox (admin-security) #> group add Group_1
A list of attributes with formatting and default values will follow
Enter a new value or simply press the ENTER key to accept the current value
with exception of the Group Member WWN field which is mandatory.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Group Name Group_1
Group Type ISL
Member (WWN) [00:00:00:00:00:00:00:00] 10:00:00:c0:dd:00:90:a3
Authentication (None / Chap) [None ] chap
PrimaryHash (MD5 / SHA-1) [MD5 ]
PrimarySecret (32 hex or 16 ASCII char value) [ ] 0123456789abcdef
SecondaryHash (MD5 / SHA-1 / None) [None ]
SecondarySecret (40 hex or 20 ASCII char value) [ ]
Binding (domain ID 1-239, 0=None) [0 ]
Finished configuring attributes.
To discard this configuration use the security cancel command.