7 – Zoning Configuration
Displaying Zoning Database Information
59183-02 A 7-5
A
7.1.3
Merged Zone Set Information
A merged zone set is a zone set that is received from another switch as a result of
a change in active zone sets. You can display the merged zone set on your switch
if the MergeAutoSave parameter is set to False. Refer to “Configuring the Zoning
Database” on page 7-10 for more information about the MergeAutoSave
parameter. Enter the Zoning Merged command to display merged zone set
information as shown in the following example:
SANbox #> zoning merged
*********************************************************************
To permanently save the merged database locally, execute the
'zoning merged capture' command. To edit the merged database
use the ’zoning edit merged’ command. To remove the merged database
use the ’zoning restore’ command.
**********************************************************************
Merged (unsaved) Zoning Information
ZoneSet Zone ZoneMember
------- ---- ----------
ZS1
Z1
10:00:00:c0:dd:00:b9:f9
10:00:00:c0:dd:00:b9:fa
Z2
10:00:00:c0:dd:00:b9:fb
10:00:00:c0:dd:00:b9:fc
7.1.4
Edited Zone Set Information
The edited zone set is a zone set that you were modifying when a change in
active zone set or a fabric merge occurred. Enter the Zoning Edited command to
display the unsaved edited zone set information as shown in the following
example:
SANbox #> zoning edited
Edited (unsaved) Zoning Information
ZoneSet Zone ZoneMember
------- ---- ----------
ZS1
Z1
10:00:00:c0:dd:00:b9:f9
10:00:00:c0:dd:00:b9:fa