Filter
Top Products
14 – Command Reference
Set Config Switch
14-80 59183-02 A
S
Set Config Switch
Sets the switch configuration parameters. The changes you make with this
command are not retained when you reset or power cycle the switch unless you
save them using the Config Save command.
Authority Admin session and a Config Edit session
Syntax set config switch
This command initiates an editing session in which to change switch configuration
settings. The system displays each parameter one line at a time and prompts you
for a value. For each parameter, enter a new value or press the Enter key to
accept the current value shown in brackets. Table 14-19 describes the switch
configuration parameters.
Table 14-19. Switch Configuration Parameters
Parameter Description
AdminState Switch administrative state.
Online – Activates and prepares the ports to send data.
This is the default.
Offline – Prevents the ports from receiving signal and
accepting a device login.
Diagnostics – Prepares the ports for testing and prevents
the ports from accepting a device login.
Down – Disables the ports by removing power from the
port lasers.
BroadcastEnabled Broadcast. Enables (True) or disables (False) forwarding of
broadcast frames. The default is True.
InbandEnabled Inband management. Enables (True) or disables (False) the
ability to manage the switch over an ISL. The default is True.
FDMIEnabled Fabric Device Monitoring Interface. Enables (True) or dis-
ables (False) the monitoring of target and initiator device
information. The default is True.
FDMIEntries The number of device entries to maintain in the FDMI data-
base. Enter a number from 0–1000. The default is 1000.
DefaultDomainID Default domain ID. The default is 1.
DomainIDLock Prevents (True) or allows (False) dynamic reassignment of
the domain ID. The default is False.
SymbolicName Descriptive name for the switch. The name can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is SANbox.