Filter
Top Products
6.5 Installing a Fibre Channel Option
CAUTION
Be sure to turn the library’s power off before installing or removing a Fibre Chan-
nel Option.
6.5.1 Installation
The following steps outline the actions necessary to install a Fibre Channel Option
onto a library.
1. Remove power from the TLS: first turn the power switch off and then remove the
power cord.
2. Using a Phillips screwdriver remove the six screws securing the service panel on
the rear of the library – refer to Figure 6-9. Depending of the model of library,
the service panel may not have ventilation slots. Care must be taken to not re-
move the four screws securing the heatsink panels. Save the service panel for
possible future use.
Phillips Screws (6)
Do not remove
these screws
Do not remove
these screws
Figure 6-9 Service Panel
3. Place the lower lip of the FCO inside the bottom edge of the service panel open-
ing and tilt the FCO upwards, making sure that the heatsink panel screws align
501440 Rev. G FCO Type C Installation 6-11