Filter
Top Products
Chapter 2 Installation and Quick Start
Quick Start Guide
4 LTO-2 Half-Height Tape Drive User’s Guide
Quick Start Guide 2
Use the following quick-start instructions to get your tape drive up and
running as quickly as possible.
Internal LTO-2
Half-Height Tape
Drive Quick Start
2
Use the following procedure to install internal LTO-2 Half-Height Tape
Drive. Print this page and check each step as you complete it. If you need
more information about a step, turn to the section referenced in the step.
1 Unpack the contents of your drive package, and check for damaged items.
See Unpacking and Inspection
.
2 Review the drive’s default settings and change them if necessary:
•SCSI ID: 6
• Terminator Power: Disabled
See Configuring the Internal Tape Drive
on page 7.
3 Turn off your computer, remove its covers and power cable, and select a mounting
bay for the drive.
See Mounting the Internal Tape Drive
on page 11.
4 Connect a SCSI interface cable to the drive.
See Connecting a SCSI Cable
on page 13.
5 Terminate the SCSI bus if the internal tape drive is the last device on the SCSI bus.
See Checking the SCSI Termination
on page 14.
6 Connect a serial cable, if connecting the tape drive to a tape library.
See Connecting a Serial Cable for Tape Libraries
on page 14.
7 Connect a power cable to the drive.
See Connecting a Power Cable
on page 15.
8 Replace the computer covers and power cable, turn on the computer, and verify
that the internal tape drive is operating properly.
9 Register your tape drive.
See Registering Your Tape Drive
on page 15.