Filter
Top Products
Chapter 2 Installation and Quick Start
Installing an Internal LTO-2 Half-Height Tape Drive
LTO-2 Half-Height Tape Drive User’s Guide 13
Connecting a SCSI
Cable
2
The internal LTO-2 Half-Height Tape Drive has an Ultra3 SCSI interface,
terminated by an LVD SCSI connector. Use the following procedure to
connect a SCSI cable to this connector.
1 Turn off all power to the drive and the computer.
2 Attach the SCSI interface cable to the 68-pin SCSI interface connector
on the back of the drive (see figure 5
).
Figure 5 Rear View of
the Internal LTO-2
Half-Height Tape Drive
Caution: Install an LVD drive only in an LVD environment.
Plugging an LVD drive into an HVD bus makes the entire
bus non-functional and may permanently damage the
drive or other SCSI devices on the bus.
SCSI Jumper Block
Pin 1
Library Interface Connector
SCSI Connector
Power Connector