Filter
Top Products
Chapter 6 UNIX Settings
Configuring for HP-UX 11.0
62 LTO-2 Half-Height Tape Drive User’s Guide
Where:
•
x is the data under H/WPath from the ioscan.
•
y is the data under I from the ioscan.
•
z is the tape device identifier number.
You can execute an
ls command for the /dev/rmt directory to choose an
identifier number that has not already been used. You can also choose a
unique device name such as cnb to more easily remember which device
name will enable data compression during write. Refer to the man pages
for
mksf to review settings for rewind/no rewind, Berkeley mode, and
AT&T mode.
After performing the insf and mksf commands, use the command
ioscan –fn | grep –C tape to check the installation. You should see output
showing the hardware and device addressing and also the device name
attached to the LTO-2 Half-Height Tape Drive.