Filter
Top Products
ASM-60 Installation and Operation Manual Appendix A IR-ETH Interface Module
Installation and Operation A-3
A.3 Installation and Operation
Figure A-4 shows the Ethernet bridge layout, the location of the DIP switch, and
the rear panel components of the IR-ETH interface module with RJ-45 connector.
Figure A-4. IR-ETH Layout (UTP Option)
DIP Switch Settings
Table A-2 describes functions and default settings of the DIP switch SW-1 sections.
Table A-2. DIP Switch Settings
Section
Number
Name Description Default
Setting
1 SQ/FD ON – Full-duplex operation
OFF – Half-duplex operation
OFF
2 CMP ON – Strips padding bits inserted in 64-byte frame
OFF – Transmits frames over WAN as is
OFF
3 FIL ON – Passes only frames destined for another LAN
OFF – Disables LAN filter; passes all frames transparently
OFF
4
(nc)