Filter
Top Products
6 ST60 Tridata Instrument Owner’s Manual
Trip screen
The trip screen shows the distance covered since the trip value was last
reset.
The trip value is reset automatically at power-up,and if the instrumentis
operating as a master,the trip value can also be reset manually by
pressing the
reset key for 3 seconds.
Water temperature
The water temperature is shown in either degrees Celsius (°C)or
Fahrenheit (°F),as set during calibration (see Chapter 4, Calibration).
Timers
The count-up timer and to the two race-start timer times are either in
seconds(S) or minutes (M), depending on the counter values.
Referto the Using the trip key flowdiagram todisplaythe requiredtimer.
Once you have done this, press the reset key to start the timer running.
When a timer is running, the delimiter (i.e. ‘.’or ‘:’) flashes. For lap
timing,press the reset key. To stop and reset a timer to the start value,
holddown the reset key for 1 second.
Onceatimerisrunning,youcan leavethetimer pageand selectanyother
display. The counter will continue to run in the background.
Race-start timers
You can set each race-start timer to any whole-minute value from 1 to 15
minutes.
Note: When the instrument is first installed, the race-start timers are set
to 4 and 5 minutes respectively.
To set a race-start timer:
1. Use the trip keyasshowninthe Using trip key flowdiagramto select
the required race-start timer.
2. Simultaneouslypress the trip and reset keys to enter the race-start
timeradjustmode.
3. Use either the trip or reset key to set the required value.
4. Simultaneouslypress the trip and reset keys to save the value and
leave the race-start timer adjust mode.
81040_1.book Page 6 Thursday, November 7, 2002 10:21 AM