Filter
Top Products
18 ST60 Tridata Instrument Owner’s Manual
3.2 Procedures
As it is not possible to describe procedures for all possibleinstallation
scenarios,the procedures givenhere describe the broadrequirements for
installing the Speed and Depth transducers and the ST60 Tridata
instrument. Adaptthese procedures as appropriate, to suit your
individualrequirement.
CAUTION:
Where it is necessary to cut holes (e.g. for cable routing and
instrument mounting), ensure that these will not cause a hazard by
weakening critical parts of the vessel’s structure.
Unpacking
Unpack your ST60 equipment and check that the items described in
Introduction are present.
Each ST60 instrument is supplied with a standard bezel for surface
mounting.Optional mounting kits are available for flush mounting and
bracketmountingtheinstrument.If youhaveorderedthe flushmounting
option a low-profilebezel and four fixing screws are also provided.
Fitting the instrument
The ST60 Tridata instrument can be installed using one of a number of
different mountingoptions:
• Surface mounting. Gives a profile of approximately 24 mm.
• Flush mounting.Gives a profileof approximately 6 mm.
• Bracket mounting.
The ST60 instrumentscanalso be mounted behind a panel with just the
instrument dial and keys visible.
Surface mounting
To surface mount your ST60 instrument (seethe Surface mounting
illustration):
1. Ensure that:
• Theselected location is clean, smooth and flat.
• Thereis sufficient space behind the selected location to accom-
modate the rear of the instrument and connectors.
81040_1.book Page 18 Thursday, November 7, 2002 10:21 AM