Filter
Top Products
Chapter 1: Operation 7
If you are using one of the race-start timers and the timer buzzer is
enabled, the buzzer will:
• Double-beep every minute.
• Beep three times at the start of the last 30 seconds.
• Beep once for each of the last 10 seconds.
• Beep for 2 seconds at zero.
The timer buzzer is enabled or disabled as part of the calibration
procedure (see Chapter 4, Calibration).
Note:After a race-start timer has counted-down to zero, it will then start
counting up.
1.3 Alarms
An alarm condition occurs if:
• The depth is less than the SHALLOW or SHALLOW anchor threshold.
• The depth is greater than the DEEP anchor threshold.
• The depth crosses the DEEPthreshold.
An alarm condition is indicated by an alarm buzzer and a flashing alarm
symbol ( ) on the display.SHALLOW or DEEP alarms are indicated by up
and down arrows respectively,and for anchor alarms an anchor symbol
( ) is displayed.
When the instrument is operating as a master, you can check the alarm
thresholds and if necessary set them up, as detailed under Normal
operation - Depth.If an alarmis not enabled,the associateddisplay
showsan OFFlegend.
1.4 Display settings
Illumination
When the instrumentis first poweredup,the displayillumination is setto
its lowest (courtesy) level, to facilitate initial access to the keys.
To adjustthe levelof displayillumination:
1. Hold down the
depth key for approximately one second, to enter the
illumination-adjust mode.
2. There are four preset illumination levels. Use the
depthkeytocycle
through these levels until you reach the level you want.
81040_1.book Page 7 Thursday, November 7, 2002 10:21 AM