Filter
Top Products
2 SpeedTouch™ Local Networking Setup
E-DOC-CTC-20040123-0001 v3.0
13
2.2 USB Connection Setup for Microsoft Windows
Supported Operating
Systems
Installing and using the SpeedTouch™ USB connection is supported by Microsoft for
following Microsoft Operating Systems:
• MS Windows 98SE
• MS Windows Millennium
• MS Windows 2000
• MS Windows XP
You may need the Windows installation CD-ROM during installation.
Note The installation procedures might be slightly different depending on the MS
Windows OS you are using:
System requirements • For Windows 98SE/ME:
• Pentium processor 166 MHz or compatible
• 32 megabytes (MB) of memory
• For Windows 2000/XP:
• Pentium II processor or compatible
• 64 MB of memory
• 30 MB of free disk space
Prerequisites It is strongly advised to remove any SpeedTouch™ USB driver installation that may
reside on your PC before you install the USB drivers from the SpeedTouch™ Setup
CD-ROM delivered with your SpeedTouch™580(i) product.
Make sure both your PC and SpeedTouch™ are turned on and operational.
Note In the SpeedTouch™ package, a blue USB cable is included to connect a
single computer to your SpeedTouch™.
Installing the
SpeedTouch™ USB
connection
The installation is plug and play, meaning that installation will require almost no effort.
Proceed as follows:
1 Insert the blue USB cable provided into the SpeedTouch™ USB port marked with
the USB logo: .
2 The other end of the USB cable fits in (one of) the USB port(s) of your PC. In
most cases your PC's USB port is marked with the same USB symbol.
Note You can also connect your PC to the SpeedTouch™ via a USB hub.
3 Windows will automatically recognize the Thomson USB Remote NDIS device: