Filter
Top Products
5 SpeedTouch™ Web Interface
E-DOC-CTC-20040123-0001 v3.0
70
DHCP The Dynamic Host Configuration Protocol (DHCP) page allows you to:
• Click The DHCP Server tab to access the DHCP server pages.
• Select Server Config to enable/disable the SpeedTouch™ (Auto)DHCP
server:
Depending on the DHCP server status, following Status message can be
displayed:
• Scanning for other DHCP server
In case the DHCP server and its Auto DHCP feature are enabled,
during local network probing on the SpeedTouch™ Ethernet interface
eth0.
• DHCP server stopped
In case the DHCP server and its Auto DHCP feature are enabled, and
a concurrent DHCP server was found during probing, thus causing its
own DHCP server to be stopped and a DHCP client on the Speed-
Touch™ Ethernet interface eth0 be created and activated.
• DHCP server started
In case the DHCP server and its Auto DHCP feature are enabled, and
no concurrent DHCP server was found during network probing, thus
starting its own DHCP server on the SpeedTouch™ Ethernet interface
eth0.
• DHCP server running
In case the SpeedTouch™ DHCP server is enabled by default (without
DHCP client)
• DHCP client
In case the SpeedTouch™ server is disabled by default, and a DHCP
client is running on the SpeedTouch™ Ethernet interface eth0.
• No DHCP
In case the SpeedTouch™ server is disabled by default and the Speed-
Touch™ Ethernet interface eth0 IP address is statically assigned.