Filter
Top Products
( 21 / 42 )
4.5 Connection to the Target System
(1) For 4514 Group
When connecting the M34514T-MCU board to the target system:
a. Connecting to 2.54-mm-pitch Dual-in-line Pins on the Target System
Use the 50-wire normal-pitch cable (included) to connect the 50-pin dual-in-line pins on the
target system. Following products are required for connection to the target system.
• 100-wire half-pitch cable (40 cm)
• PCA4029 pitch converter board
• 50-wire normal-pitch cable (10 cm)
Figure 4.8 depicts the M34514T-MCU board connected to the target system using the 50-wire
normal-pitch cable. Table 4.8 lists the connector signal assignments of the 50-wire normal-pitch
cable. Figure 4.9 shows the pin layout of the 50-wire normal-pitch cable.
Figure 4.8 Connection to the target system using dual-in-line pins