Filter
Top Products
( 23 / 42 )
Figure 4.10 Connecting to IC socket for 32-pin SDIP
(2) For 4513 Group
When connecting the M34514T-MCU board to the target system (for 4513 Group):
a. Connecting to the IC socket for 32-pin SDIP on the Target System
Connect the M34514T-MCU board with the IC socket for 32-pin SDIP on the target system
using the 50-wire normal-pitch cable (included) with the M34513T-PTCA pitch converter
board attached. Figure 4.10 depicts the connection between the M34513T-PTCA pitch con-
verter board and the target system. Following products are required for connection to the target
system.
• 100-wire half-pitch cable (40 cm)
• PCA4029 pitch converter board
• 50-wire normal-pitch cable (10 cm)
•M34513T-PTCA pitch converter board
Table 4.9 shows the connector signal assignments of the M34513T-PTCA pitch converter
board. The pin assignments of M34513T-PTCA is the same as for the 32SDIP in 4513 Group.
When connecting the M34513T-PTCA pitch converter board, make sure the No. 1 pin position
of each connector is aligned with that of cable. To avoid damage to the emulator and target
system, be careful of the connection.