( 11 / 64 )
IMPORTANT
Note on Malfunctions in the PC4701 System:
• If the emulator malfunctions because of interference such as external noise, do the following to
remedy the trouble.
(1) Press the RESET button on the emulator front panel.
(2) If normal operation is not restored after step (1), shut OFF power to the emulator once and then
reactivate it.
Notes on Downloading Firmware:
• Before using this product for the first time, it is necessary to download the dedicated firmware
(control software for the emulation pod built into the PC4701). Please note that, to do this, it is
necessary to start up the PC4701 in maintenance mode. For firmware download procedures, see
"4.2 Downloading Firmware" (page 35). Once the firmware has been downloaded, the product can
be used by simply turning on the power.
• Do not shut off the power while downloading the firmware. If this happens, the product will not
start up properly. If power is shut off unexpectedly, redownload the firmware.
• Except when a target status error occurs, if self-checks are not completed successfully, there may
be trouble with the product. In such case, contact your sales representative. However, perform self-
checks in the below setup.
(1) Target system: Not connected
(2) Emulation pod internal switches: At their factory settings
Note for PC4700 System:
•PC4700H products whose serial number ends with a number or D, DE, G cannot be used with the
M37760T-RPD-E.
Example: 5KE100, 5KE100D, 5KE11DE, 5KE100G
Cannot be used with the M37760T-RPD-E. Upgrade your PC4700.
Example: 5LE123B
Can be used with the M37760T-RPD-E.