Filter
Top Products
Memory Unit TypeB 64MB
19
2
G
GG
G
Place the controller board on a flat
surface.
H
HH
H
Insert the Memory unit to the slot
by placing the notch of the unit to
the projection of the slot, and
then push it down until it clicks.
I
II
I
Match the controller board to the
top and bottom rail using the "T
TT
T"
mark, and then slide it into the
printer slowly until it stops.
J
JJ
J
Push the handle of the controller
board until it clicks.
K
KK
K
Fasten the controller board to the
printer with the two screws.
Note
❒ If the Duplex Unit is not at-
tached, go to step
N
.
L
LL
L
While aligning the power cord to
the left side groove of the Duplex
Unit, slide the Duplex Unit in un-
til it is connected to the printer.
M
MM
M
Attach the interface cable to the
printer.
ZGDX130J
ZGDX250J
ZGDX380J
ZGDX270J
ZGDX240J