Ricoh 400780 Printer User Manual


 
Network Interface Board Type 2610
21
2
Network Interface Board Type 2610
Note
Depending on the model you use,
the Network Interface Board , the
1394 Interface Unit, and the
802.11b Interface Unit cannot be
installed to the printer at the same
time. For more information, see
p.11 Installing Options.
Important
Before touching the Network In-
terface Board, touch something
metal to discharge any static elec-
tricity. Static electricity can dam-
age the Network Interface Board.
Use the shielded twisted-pair
(STP) network interface cable.
Installing the Network
Interface Board
A
AA
A
Check the contents of the box for
the following items:
Network Interface Board
Ferrite Core
Installation Guide
B
BB
B
Confirm that the followings are
true:
The power switch is turned off.
The interface cable is un-
plugged from the printer.
Note
The interface cable is not includ-
ed in the box. Make sure that the
interface cable you use is appro-
priate for your computer.
If the Duplex Unit is not at-
tached, go to step
D
.
C
CC
C
If the Duplex Unit is attached,
push down the lever on right side
(A
AA
A) and pull out the Duplex Unit
until it stops (B
BB
B).
D
DD
D
Use a coin to remove the two
screws.
Note
These screws are used again in
step
M
.
ZGDX320J
ZGDX281J