Filter
Top Products
DISK DRIVE OPERATION
SpinPoint V40 Product Manual
57
Table 6-5 Diagnostic Codes
Code Description
01h No error detected
02h Formatter device error
03h Sector buffer error
04h ECC circuitry error
05h Controlling microprocessor error
8xh Drive 1 failed
6.4.4 Flush Cache (E7h)
This command is used by the host to request the drive to flush the write cache. If write is to be flushed, all
data cached will be written to the media. The BSY bit will remain set to one until all data has been
successfully written or error occurs.
6.4.5 Format Track (50h)
The track address is specified in the Cylinder High and Cylinder Low registers, and the number of sectors is
specified in the Sector Count register. When the command is accepted, the drive sets the DRQ bit and waits
for the host to fill the sector buffer. When the sector buffer is filled, the drive clears DRQ, sets BSY, and
begins command execution. SpinPoint V40 hard disk drives write zeros to the data fields in the sectors on the
specified logical track. The ID fields are not written by this command.
In LBA mode, this command formats a single logical track including the specified LBA.
6.4.6 Identify Device (ECh)
The Identify Device command enables the host to receive parameter information from the device. When the
command is issued, the device sets the BSY bit, prepares to transfer the 256 words of device identification
data to the host, sets the DRQ bit, clears the BSY bit, and generates an interrupt. The host can then transfer
the data by reading the Data register. The parameter words in the buffer have the arrangement and meanings
defined in Table 6-6. All reserved bits or words shall be zero.
The F/V column indicates if the word or part of a word had fixed (F) contents that do not change, variable
(V) contents that may change depending on the device state or the commands executed by the device, X for
words with vendor specific data which may be fixed or variable, and R for reserved words which shall be
zero. For removable media devices, the value of fields indicated as fixed (F) may change when media is
removed or changed.