Filter
Top Products
1.23
Setting up your machine
1 Getting Started
Adjusting speaker volume
1. Press OHD
1)
/V.Req. to adjust the speaker volume. If you cannot hear a
dial tone, check the phone line connection.
2. Press
„„
or repeatedly until you find the desired loudness. The display
shows the current volume level.
3. After choosing the desired volume level, press OHD
1)
/V.Req..
Note :
1)
OHD : On Hook Dial
Setting the date and time
The current date and time are shown in the display window when the
machine is on and ready for use (standby mode). The date and time are
printed on all faxes you send.
1. Press Menu, then press Date & Time on the one-touch keypad.
The display shows the currently set date and time.
2. Using the number keypad, enter the current date in MMDDYYYY format.
If you make a mistake, use the
ˆˆ
or
¤¤
buttons to move the cursor to the
digit you wish to change.
05-03-1999
08:36 (PM)
After entering the date the flashing cursor will move into the first digit of
the time.
3. Using the number keypad, enter the current time. You can choose 12 or
24 hour format. Refer to the previous section, for the details see page 2.47
clock mode.
Note : AM or PM is selected by pressing the
„
or buttons.
4. Press Start/Enter when the date and time in the display is correct.
The display shows the date and time you have set, then returns to
standby mode.
Note : If you enter an invalid number, the machine beeps and will not proceed to
the next step. If this happens, just reenter the correct number.