Filter
Top Products
2.22
Receiving a fax
9. Press Start/Enter. The LCD displays the current time on the upper line
and asks you to enter the time when the fax is to be sent.
10. If you want to send it at a later time, enter the time you want your
machine to send the document. If you want to send the document
immediately, skip over this step.
Enter the time in same format (12/24 hour) as current time.
If you set a time earlier than the current time, the document will be sent
at that time on the following day.
Note: AM or PM is selected by pressing for the
„
or buttons.
11. Press Start/Enter when the time appears correctly in the LCD. The
document will be scanned into memory before transmission. The LCD
displays the memory capacity and the number of pages.
Note: You can change your machine not to scan the document into memory
automatically. Refer to ‘Send from memory’ under ‘User options’ on page
2.47. If you turn this feature off, the LCD prompts you at this step to choose
either to scan into memory before transmission or not.
If you cannot fit all the pages in memory, the machine automatically begins
to send the document without waiting all the pages are scanned. But if you
registered delayed transmission at step 10, the LCD displays ‘MEMORY
FULL’ and ‘CANCEL ?.’
To cancel the job, press 1. If you press 2, the pages already scanned will be
sent, and you should send the remaining pages in a separate operation.
The machine returns to standby mode.
Note: To cancel the confidential transmission setup, see ‘Canceling a standby
operation’ on page 2.16.
In case a document loaded in the automatic document feeder, you cannot
perform any more tx job such as delay Tx, conf. Tx, and Tx poll unless the
document is sent out.
CURRENT 02:30PM
START 02:30PM
SCAN TO MEMORY
95% P. 001
TOTAL PAGES=007
18-JUL-1998 95%
CONF. TX 03:30PM