Sanyo POA-PN40 Network Card User Manual


 
19
PJ-NET ORGANIZER
OWNER'S MANUAL
ENGLISH
2 Configuration for IP Address/ Sub net/ Gateway*
1
/DNS*
2
Press SELECT button again. The following network setting pallet appears on the
screen. Enter the specified network addresses.
How to enter the numbers
There are 2 ways to enter the numbers, one is by using the point buttons (d e ) on
the remote control or on the projector, the other is by using the screen 10-key pallet
by which the numbers can be entered directory. For further information see "How
to enter the numbers with the screen 10-key pallet" (
p.21).
3 Fixing the network configuration
After completing the entering of address, select "SET"
and press
SELECT button.
The Network Unit starts re-
booting and displays message "Please wait..." on the
screen until the re-booting is complete.
Do not discon-
nect the AC cord during this period. After that the menu will disappear on the screen.
Completing of installation
Now the installation is complete. The IP address of this projector is set to
"192.168.1.201".
Item Description
IP address ..........Sets IP address of the projector
Sub net ..............Sets Subnet mask. Normally sets 255.255.255.0
Gateway*
1
..........Sets IP address of the default gateway (Router)
DNS*
2
................Sets IP address of the DNS server. Must be set when using the e-mail function
*1 In the network environments not using a Gateway or Router, the Default Gateway address
should be set to [0.0.0.0].
*2 If you do not use the functions E-mail or DNS server, it is also set [0.0.0.0] for the DNS
address.
Refer to the projector's owner's manual for operation of the projector.
Installation and network configuration
The red frame moves
sequentially left or right
with 7 8 button.
The number up or down
with d e button.