Filter
Top Products
59
PJ-NET ORGANIZER
OWNER'S MANUAL
ENGLISH
Multi-control
Status
If some of the registered projectors are disabled by
some reasons (such as disconnecting the power
source, disconnecting the LAN cable, disconnecting
from the network), control changes will continue to
be effective for the projectors that are still active.
At the same time, the deactivated projectors are
excluded from the multi-control. The status of the
registered projectors are indicated under the projec
-
tor name. See the table below for status indications.
✐ If the multi-controlled projector is in the standby mode, any change is not effective except
timer setting.
✐ It is recommended that a specified projector should be chosen for setting as a master when
you use this multi-control function. The control for the multi-controlled projectors will become
too complicated operation if this function is used for each projector.
✐ If the registered projector is not connected to the network, it will take some time to complete
the multi-control operation because of waiting for the response from each registered projector.
Change the mode of the registered projector
To change the mode of the registered projector, select a mode with the pull-down
menu button under the IP address of the target projector and then click
Set button.
Status Description
(blank) ................ The projector is connected to the network correctly
No connect ............ The projector may not be connected to the network. Please check the connection and
network configuration of this projector.
PIN code error ....... The PIN code is incorrect. The PIN code for the multi-controlled projectors must be
the same. Change the PIN code of this projector to the common PIN code.
* The Network Unit updates the status at the time when the multi-control function was executed.
Mode Operation
Control ................. Multi-controlling the projector
OFF ..................... Excluding from the multi-control
Delete .................. Deleting from the multi-control
Status
* This function is not available with the Light mode.