Sanyo POA-MD13NET2 Network Card User Manual


 
14
Chapter 2 Installation
1 Turn the Mains switch off.
NOTE;
When replacement of terminal board,
MAIN ON/OFF switch should be OFF
position.
2 Remove 2 screws on a board
from any of the slots 1 to 4*,
and then pull the board out from
the projector.
* The number of the slots may
differ from the actual depend-
ing on type of the projector.
3 Put the Board into the board slot
along the guide. Mount the
board connector into the socket
in the slot firmly.
4 Secure the board with two screws
(supplied).
Mains switch must be turned off when mounting or removing this product otherwise it may
damage the product.
Do not install multiple network boards into a projector otherwise it may damage the product.
Do not connect the AC cord until after connecting the LAN cable and computer.
Caution
!
Guide
Mains Switch
* Mounting example of the 2 slots model.
x Installation and Network configuration
Mounting