17
Network Board
OWNER’S MANUAL
ENGLISH
2 Configuration for IP Address/ Subnet mask/Default Gateway*/DNS*
Press SELECT button again. The following network setting pallet appears on the
screen.
Enter the specified network addresses.
How to enter the numbers
There are 2 ways to enter the numbers, one is by using the point buttons (d e )
on the remote control or on the projector, the other is by using the screen 10-key
pallet by which the numbers can be entered directory. For further information see
"How to enter the numbers with the screen 10-key pallet" (☞ p.19).
3 Restart the Network board
After completing the entering of address, select "Set"
and press SELECT button. The network unit starts re-
booting and displays message "Please wait..." on the
screen until the re-booting is complete. Do not turn
off the mains switch during this period.
Completing of installation
Now the installation is completed. The IP address of this projector is set to
“192.168.1.201”.
*1 In the network environments not using a Gateway or Router, the Default Gateway address
should be set to [0.0.0.0].
*2 If you do not use the functions E-mail or DNS server, it should also be set to [0.0.0.0] for the
DNS address.
The red frame moves
sequentially left or right with
7 8 button.
The number up or down with
d e button.
Item Description
IP address..........Sets IP address of the projector
Subnet ..............Sets Subnet mask. Normally sets 255.255.255.0
Gateway*
1
........Sets IP address of the default gateway (Router)
DNS*
2
..............Sets IP address of the DNS server. Must be set when using the e-mail function
*Refer to the projector's owner's manual for operation of the projector.
For the Projector which provides the Network main menu
Network configuration