SATO ct4i Label Maker User Manual


 
Unit 3: Installation
CT4i Series Operator Manual 3-5
UNPACKING & PARTS IDENTIFICATION
When unpacking the printer, take note of the following:
Note:
The following parts shown here are representative only. Due to regional requirements and our policy of continual
improvement, your printer may not be packed with the exact parts as shown here, but the unpacking steps are
similar.
Figure 3-1, Unpacking & Parts Identification
The box should stay right-side up.
Lift the printer out of the box carefully.
If the printer has been stored in the
cold, allow it to reach room
temperature before turning it on.
Remove the plastic covering from the
printer.
Set the printer on a solid, flat surface.
Inspect the shipping container and
printer for any sign of damage that
may have occurred during shipping.
Remove the accessory items from their
protective containers.
1
4
2
5
3
CT4xxi Printer
User documentation and software
package (where applicable)