SATO ct4i Label Maker User Manual


 
Unit 4: Printer Configuration
CT4i Series Operator Manual 4-6
Switch 6: VR1 Potentiometer Adjustment mode
Selects the function adjusted by VR1. If DSW6 is Off, VR1
adjusts the pitch offset value over a range of +/- 3.75 mm.
When DSW6 is On, VR1 adjusts the print darkness range.
Switch 7: DATA Dump
When ON, the printer will print out the hex value for each
character received. When OFF, the printer will accept and
process the data stream in a normal fashion.
Switch 8: Interface Board selection
This switch lets you choose whether to use the factory
installed interface board connectors, or the user-installable
Extended Interface board.
If not extended interface board is detected, switching
DSW8 to Off will not affect the use of the built-in interface.
DSW6 Mode
Off Pitch Offset
On Print Darkness
Configuration Switch
ON
OFF
12345678
DSW7 Mode
Off DISABLED
On ENABLED
Configuration Switch
ON
OFF
12345678
DSW8 Mode
Off Use extended
interface
On Use internal
interface
Configuration Switch
ON
OFF