Filter
Top Products
Unit 5: Printer Configuration
SATO MB2i Service Manual PN 9001145B Page 5-4
CONFIGURATION MODES
This chapter provides an overview of the various configuration modes of the operation menu. All
of the following configuration activities are performed via the use of the operator panel located on
the printer front. However, many settings may also be controlled via software commands. In the
case of conflict between the software and control panel settings, the printer will always use the last
entered valid setting.
NORMAL MODE
When in the Normal Mode the printer is online and ready for print activity. If print activity,
downloading, or other interaction does not occur, the printer will go into the Sleep Mode and from
there, into the Offline Mode.
Refer to Figure 1-1 in the Introduction unit of this manual for dipswitch location.
Figure 5-1, Normal Mode
RS232C: (DSW = 1: OFF, 2: OFF, 3: OFF, 4: OFF) + POWER
Wireless LAN: (DSW = 1: OFF, 2: ON, 3: OFF, 4: OFF) + POWER
Bluetooth: (DSW = 1: OFF, 2: ON, 3: OFF, 4: OFF) + POWER
Infrared: (DSW = 1: ON, 2: OFF, 3: OFF, 4: OFF) + POWER
PRINT
Flashes orange,
goes online,
flashes green
FEEDFEED
LED
terminates and printer goes
offline
Label is fed