Filter
Top Products
Unit 6: Troubleshooting
SATO MB2i Service Manual PN 9001145B Page 6-6
TEST LABEL PRINTING
The test label is designed to assist in the identification of print problems. Follow the flow chart
provided below to perform this activity.
Refer to Figure 1-1 of the Introduction unit in this manual for dipswitch location.
Figure 6-2, Test Print Mode
Choose Applicable Option
RS232C: (DSW = 1: OFF, 2: OFF, 3: OFF, 4: OFF) + FEED + POWER
Wireless LAN: (DSW = 1: OFF, 2: ON, 3: OFF, 4: OFF) + FEED + POWER
Bluetooth: (DSW = 1: OFF, 2: ON, 3: OFF, 4: OFF) + FEED + POWER
Infrared: (DSW = 1: ON, 2: OFF, 3: OFF, 4: OFF) + FEED + POWER
FEED
Flashes
orange and enters the
Test Print Mode. Blinks green
while waiting.
FEED
Confirm printing has
stopped and press
POWER.
Pause printing.
Test printing begins.
Flashes green.
Printer shuts down.