Filter
Top Products
Unit 7: Replacement Procedures
SATO MB2i Service Manual PN 9001145B Page 7-13
Figure 7-9b, Gap Sensor Replacement
COVER-OPEN SENSOR REPLACEMENT
1 Switch off the printer and remove power supply.
2 Remove the front and left housing covers to gain access to the cover-open sensor.
3 Disconnect the eye-mark sensor from cover-open sensor board (Figure 7-10a).
Figure 7-10, Cover-Open Sensor Replacement
NOTE: Figure 9-1 of the Charts & Diagrams unit provides guidance on
housing cover removal.
Sensor Guide
Print Head
Main Board
Cover-Open Sensor
Screws x2
Eye-Mark Sensor
Screws x1