Filter
Top Products
47
5
About interrupt copying
If you press the start ( ) key to begin a copy job while a print job using the paper
tray or multi-bypass tray is in progress, the copy job will begin automatically after the
print data in the unit's memory is printed (interrupt copying). When this is done, the
print data remaining in the computer is not sent to the unit. When the copy job ends,
press the clear key twice, or press the ONLINE key once to change the unit to the
online state (p.33), or wait until the set auto clear time (p.55) elapses. The remaining
print data will be sent to the unit and printing will resume.
* Interrupt copying during two-sided printing is not possible until the print job is finished.
(AL-2040CS only)
ORIGINAL PLACEMENT
Using the document glass
1
Open the SPF, and place the original.
2
Place an original face down on the document glass. Align it with the
original scale and the centering ( ) mark. Gently close the SPF.
After placing the original, be sure to close the SPF. If left open, parts outside of
the original will be copied black, causing excessive use of toner. In addition,
toner may scatter inside the machine or the drum cartridge may suffer damage.
• If you start a print job while a copy job is in progress, the print job will
begin when the copy job is completed.
• The scanning function cannot be used while a copy job is in progress.
(AL-2040CS only)
• The document glass can read up to 8-1/2" x 14" original.
• Image loss 5/32" (4mm) can occur at the leading and trailing edges of
the copies. Also image loss 11/64" (4.5mm) in total can occur along
the other edges of the copies.
• When copying a book or an original which has been folded or a
crumpled original, press down the SPF lightly. If the SPF is not
securely closed, the copies may be striped or blurred.
• When using the document glass to scan an original, make sure that an
original is not placed in the SPF.
mark
Original scale
AL-2030_2040CS.book 47 ページ ２００７年４月６日 金曜日 午前１１時３２分