Sharp FO-1850 Fax Machine User Manual


 
<P=005>
5
When you have finished listening to your
messages, you can do any of the follow-
ing:
Erase all messages: To erase all of
the messages in the box, press "3",
"3", and "#".
Repeat playback: To listen to your
messages again, press "7" and "#".
Perform other operations: You can
enter any of the commands described
in the following section, "Other remote
operations".
Hang up: If you do not erase your
messages first, they will be saved and
any new messages will be recorded
after them. If you want the
FO-1650/1850 to resume normal
operation immediately, press "*"
twice before hanging up (in some
cases, particularly when the Transfer
function is used, the FO-1650/1850
may not accept new calls for one or
two minutes after you hang up unless
you first press "*" twice).
Comments:
When a remote command is accepted by the machine, you will hear one beep. If
an incorrect command is entered, you will hear four beeps. In the latter case,
re-enter the correct command.
When entering a command, do not pause longer than 10 seconds between each
digit. If you do, a 4-beep error signal will be issued and the digits entered up to
that point will be disregarded. In this case, re-enter the command from the
beginning.
If you make two errors (causing two 4-beep signals to be issued) while entering
your remote code number, the line will be disconnected. This prevents
unauthorized people from attempting to guess your remote code number.
If you pause for longer than 60 seconds before entering a command, you will be
disconnected.
7
33
REMOTE OPERATIONS
USING THE ANSWERING MACHINE 4-9