Filter
Top Products
9·24
Reference
Connect support tools
· Connect a support tool with the JW-20CM
and prepare the setting parameter.
<Usable support tools>
JW-13PG/12PG
JW-50SP
JW-50PG, Z-100LP2S
• For operation of each support tool, see the
instruction manual attached. The following
describes an example of JW-13PG’s key
operation.
Stop PC operation
· Turn to program mode (stop PC operation). Setting of parameters is only available when the PC
is in program mode.
(Operation example of JW-13PG)
Stop operation of data link [HEX (hexadecimal), byte]
·Setting of the parameter is only available when the operation of the JW-20CM is stopped.
·Write “00
(H)
” to parameter address 007777
(8)
and stop operation of the JW-20CM.
(Operation example of JW-13PG)
To the next page
Display the contents of parameter
address 007777 by hexadecimal.
Write
00
(H).
Function of JW-13PG
Select initial mode
Screen display of JW-13PG
Select parameter setting mode.
Parameter
setting
• key: Changeover unit of figures
HEX (hexadecimal)
OCT (octal)
DCM (decimal) Bit pattern
• key: Byte display Changeover word display
07775 HEX 00
07776 HEX 00
I PARAM.
>07777 HEX 00
Stop PC operation
Turn “ON” the power of slave module