Sharp JW-20CM Computer Hardware User Manual


 
13·15
Instruction system
Data memory start system
Instruction system
Data memory start system
Instruction system
Data memory start system
Instruction system
Data memory start system
System of each cannel in
SEND/RECEIVE function
Whether the station number information should
be output or not
Top addresses in communication
information storage area when using
data memory starting system of
SEND/RECEIVE functions
(7/7)
Address(8)
Set contents
Setting method (value, example)
00(H)
80(H)
00(H)
81(H)
00(H)
82(H)
00(H)
83(H)
CH0
CH1
CH2
CH3
007700
007701
007702
007703
007710
007711
007712
007713
007700
to
007703
(Octal, word)
(Hexadecimal, byte)
This setting is valid by 80(H)
007710
to
007713
Bit address 76543210
007750 07 06 05 04 03 02 01 00
007751 17 16 15 14 13 12 11 10
007752 27 26 25 24 23 22 21 20
007753 37 36 35 34 33 32 31 30
007754 47 46 45 44 43 42 41 40
007755 57 56 55 54 53 52 51 50
007756 67 66 65 64 63 62 61 60
007757 77 76 75 74 73 72 71 70
Connection condition of slave station
Turn ON the corresponding bit of
connected station number (01 to
77(8)) from the list at right.
•00(8) of master station (0 bit of
address 000750)
At ON: Output error code
At OFF: Do not output error code.
007750
to
007757
• When connecting slave station 00
to 04(8) and output error code:
(Address) (Bit pattern)
007750 00011111
007751 00000000
to to
007757 00000000
00(H)
01(H)
Do not output
Output
007763
(Octal, word)
(Hexadecimal, byte)
007764
to
007767
007764
007765
007766
007767
Flag area top address on the master
station
When 0200, set to 000200(8)
(Set by file address)
00(H): Do not output flag
80(H): Output flag
When file number is 2, set to 02(H)
(Decimal, bytes)
00(H)
01(H)
80(H)
81(H)
08(H)
Stop operation of the data link
Start operation of the data link
Writing to EEPROM or operation stop operation
Writing to EEPROM or operation start operation
Initialize parameter setting value
007777
When 1100 to set to 001100(8)
(Set by file address)
When file number is 0, set to 00(H)
007771
Communication error detection interval When 600 ms, set to 006
(D)
Set in 100 ms unit
See page 9·33 for initial value of the addresses above.