Filter
Top Products
7·8
7-8 Wiring to power supply module
[1] JW-1PU
· Open the terminal block cover, fasten with the screw with torque of less than 12kg·cm.
·A maximum of three halt output lines can be connected serial. To use more than three sets, use
a relay for interconnection.
In case of 100 VAC input
In case of using DC output module, connect the AC relay in the halt output line and insert the
contact with the emergency stop circuit.
In case of 200 VAC input
· In case of using 200 VAC, switched to the 200 V side in terminal block of power supply module.
· If 200 V is added with the clip connected to the 100 V side, it may damage the power supply
module.
SHORT
200 VAC
100 VAC
or 200 VAC
SHORT
100 VAC
GND
The coil rating must conform to the power supply voltage.
In case of 100 VAC input
Terminal block cover
Terminal block
cover
DC relay
halt output
line
SHORT
200 VAC
200 VAC
input
SHORT
100 VAC
GND
Halt output internal circuit
In case of 100 VAC input