Filter
Top Products
E-56
Basic Operation
•“MNTR Out/RS232C” is factory preset to “ ”, and “Auto Power Off” is factory preset to “ ”.
These functions allow you to reduce the power consumption when the projector is in standby mode.
See page
44
for the procedure details.
Monitor Out/RS-232C Off Function
This projector consumes power when using a monitor connected to the OUTPUT port for INPUT 1, 2 and a
computer connected to the RS-232C port. When not using these ports, “MNTR Out/RS232C” can be set to “
”
to reduce standby power consumption.
Selecting the Economy Mode
Standby power for Monitor Out/RS-232C
connection turned off.
Monitor Out/RS-232C on
CAUTION
• Set “MNTR Out/RS232C” to “ ” when using the Sharp Advanced Presentation Software (supplied).
Automatic Power Shutoff Function
When no input signal is detected for more than 15 minutes, the projector will automatically shut off. The on-screen
message, “Power OFF in 5 min.” will appear five minutes before the power is automatically turned off.
Power automatically shuts off after 15 minutes
of no signal input.
Automatic Power Shutoff disabled.