Filter
Top Products
21
Using the projector
Entering the password recall procedure
1. Make sure the Input Password page displays on screen.
Press and hold PICTURE MODE on the remote control for 3
seconds. The projector will display a coded number on the
screen.
2. Write down the number and turn off your projector.
3. Seek help from the local service center to decode the
number. You may be required to provide proof of purchase
documentation to verify that you are an authorized user of
the projector.
Changing the password
1. Press MENU on the remote control and then press / until the Setup menu is
highlighted.
2. Press / to highlight Password and press ENTER. The Password page displays.
3. Highlight Change Password and press ENTER. The Input Current Password page displays.
4. Enter the old password.
• If the password is correct, the message 'Input New Password' displays.
• If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'Input Current Password' displays for your retry. You can
either press MENU to cancel the change or try another password.
5. Enter a new password.
IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected password
down here in this manual in advance or right after the password is entered so that it is available to
you should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
6. Confirm the new password by re-entering the new password.
7. You have successfully assigned a new password to the
projector. Remember to enter the new password next time
the projector is started.
8. To leave the OSD menu, press MENU.
Disabling the password function
To disable password protection, go back to the Setup >
Password > Password menu. Highlight Password and select Off
by pressing / . The message 'Input Password' displays. Enter
the current password.
• If the password is correct, the OSD menu returns to the
Password page with 'Off' shown in the row of Password.
You will not have to enter the password next time when
turning on the projector.
• If the password is incorrect, the password error message
displays lasting for three seconds, and the message
'Input Password' displays for your retry. You can either
press MENU to cancel the change or try another
password.
Note that though the password function is disabled, you need to keep the old password in
hand should you ever need to re-activate the password function by entering the old
password.
Please write down the recall code,
and contact your nearest SIM2
Customer Center.
Recall code:
255 255 255 255
Recall Password
EXIT Back
Password Changed
Password
Password
Change Password
On
EXIT Back