Sim2 Multimedia D60 Projector User Manual


 
31
Using the projector
Using anamorphic lenses (optional)
Anamorphic lenses allow you to convert 16:9 projectors to the full 2.35:1 aspect ratio of most
of major motion pictures, showing the best movies without letterbox bars at top and bottom
of images while increasing resolution by 33% and brightness by 20%.
You may need a 2.35:1 screen to display the 2.35:1 images.
Operating in a high altitude environment
We recommend you activate High Altitude Mode when your environment is higher than 1500
meters (around 4920 feet) above sea level, or whenever the projector will be used for
extended periods of time (>10 hours) without shutdown.
To activate High Altitude Mode:
1. Press MENU and then press / until the Setup menu is
highlighted.
2. Press to highlight High Altitude Mode.
3. Press / to select On. A confirmation message displays.
4. Highlight Yes and press ENTER.
Operation under High Altitude Mode may cause a higher
decibel operating noise level because of increased fan speed
necessary to improve overall system cooling and performance.
If you use this projector under other extreme conditions
excluding the above, it may display auto shut-down symptoms,
which is designed to protect your projector from over-heating.
In cases like this, you should switch to High Altitude Mode to
solve these symptoms. However, this is not to state that this
projector can operate under any and all harsh or extreme
conditions.
2.35:1 aspect ratio
image
2.35:1 aspect ratio
image using the
entire resolution of
the 16:9 display
2.35:1 aspect ratio
image in a 2.35:1
display area
Pressing LB on
the remote
control
Using
anamorphic
lens
High Altitude Mode is used when the
environment is higher than 1500m.
Do you want to turn the High Altitude
Mode on?
Yes
No
WARNING
Lamp settings
Dust Filter
High Altitude Mode
Password
Reset All Settings
Setup
EXIT Back
S-Video
On
Pattern
InformationSystem