Filter
Top Products
2 Room Control Module Installation Guide for the 3000i 99-00360-02 REV A0
Removing the Blank Panel
NOTE: We recommend that you wear the supplied anti-static wrist strap throughout the
installation process. This wrist strap protects electronic components from damage due to
electrostatic discharge. Attach the adhesive side of the strap to your wrist and wrap the copper
tape on the other end of the strip around either of the two screws shown below.
Cables removed from
illustration for clarity
Wrap the copper tape on the anti-static
wrist strap around either screw
1 Shut down the computer, and put the projector into Standby mode. Wait a full minute to allow
the fans to cool the projector, and then unplug the 3000i from the power outlet.
2 With a Phillips No. 2 screwdriver, remove the four screws used to attach the blank panel at
the left end of the patch panel (rear of cabinet). Discard the blank panel, but keep the screws
handy. You’ll need them later to install the Room Control Module.
Cables removed from
illustration for clarity
Blank Panel
Screw x 4
Patch Panel
R
e
a
r
o
f
C
a
b
i
n
e
t