Filter
Top Products
Installing the DT770 7
Installing the DT770
This chapter tells you how to:
• determine the best location for the DT770 (this page)
• remove the connection panel’s back cover (page 8)
• connect the DT770 (page 8)
• integrate a monitor or a projector (page 9)
• connect the tethered pen (page 9)
• reattach the connection panel’s back cover (page 10) (optional)
• mount the DT770 on a Mono Stand (page 11) (optional)
• secure the DT770 (page 12)
• turn on the DT770 (page 12)
• install SMART Board software (page 12)
• match your computer’s resolution setting to that of the interactive screen (page 13)
• orient the screen (page 14)
NOTE: For information on adjusting the screen settings, see page 29.
Determining the Best Location for Your DT770
When you’re deciding where to place your interactive pen display, consider the location of the
computer and its components in relation to the DT770.
Install the DT770 in a cool, dry location without excessive levels of dust, humidity and smoke.
Operate the DT770 in an environment with a temperature range between 41°F and 95°F (5°C to
35°C) and with a maximum humidity of 80% (non-condensing). You can store the DT770 in an
environment with a temperature range of -4°F to 140°F (-20°C to 60°C).
NOTE: Take into consideration that the DT770 itself will generate heat whenever it’s turned on. To
maintain a consistent operating temperature, don’t block or cover any of the ventilation holes on
the back of the unit. Other external factors can affect the DT770, such as the heat generated by
control systems or other electronic equipment. Ensure there is adequate airflow around the
DT770.
Keep the computer keyboard and the mouse close to the DT770, as the tethered pen won’t
function until you install SMART Board software and open SMART Board tools.
CAUTION
Turn off your DT770 and shut down your computer before you connect any cables.
Otherwise you may damage the DT770 or your computer.