Filter
Top Products
Installing the DT770 11
Mounting the DT770 on a Mono Stand
If you want to mount the DT770 at an angle of 30 or 45 degrees, you can install the DT770 on the
supplied mono stand.
NOTE: You can purchase and install the optional tilt stand from SMART and adjust the DT770 to a
variety of angles. As an alternative, you can purchase and install a tilt stand or mounting arm that
conforms to the 100 mm pattern set by the Video Electronics Standards Association (VESA). If you
install a VESA-compatible stand, ensure that the weight rating of the arm can support the DT770.
Use M4 screws (with a 0.7 mm pitch), and select a screw length that ensures no more than 10 mm
of the screw is threaded into the mounting plate.
1. If you have not done so already, place the DT770 facedown on a flat surface.
2. Loosen the four captive screws in the mono stand.
3. Align the captive screws in the mono stand with the four holes on the back of the interactive
pen display.
4. Tighten the four captive screws.
5. Place the DT770 face up, with its weight on the mono stand and the bottom edge of the
DT770.
To install the DT770 on the mono stand
CAUTION
Place the DT770 down slowly and carefully to ensure you don’t damage the
buttons.
Don’t place the DT770 on a surface that will mark, scratch or damage the
screen or its optical components.
Bottom Edge
of the DT770
Top Edge of
the DT770
If you want the DT770 to be on a 30°
angle, align the mono stand so the
vertical part of the stand is near the top
edge of the DT770.
If you want the DT770 to be on a 45°
angle, align the mono stand so the
vertical part of the stand is near the
bottom edge of the DT770.