Filter
Top Products
Page 14
4. Enter your subnet mask in the Subnet Mask field.
5. Click the Add button to add this client route.
Setting your NetExtender Address Range
The NetExtender IP range defines the IP address pool from which addresses will be
assigned to remote users during NetExtender sessions. The range needs to be large
enough to accommodate the maximum number of concurrent NetExtender users you
wish to support.
The range should fall within the same subnet as the interface to which the SonicWALL
SSL VPN appliance is connected, and in cases where there are other hosts on the same
segment as the SonicWALL SSL VPN appliance, it must not overlap or collide with any
assigned addresses. You can determine the correct subnet based on your network
scenario selection:
Route 1 Destination Network: 0.0.0.0
Subnet Mask: 128.0.0.0
Route 2 Destination Network: 128.0.0.0
Subnet Mask: 128.0.0.0
Scenario A Use the default NetExtender range:
192.168.200.100 to 192.168.200.200
Scenario B Select a range that falls within your existing DMZ subnet. For
example, if your DMZ uses the 192.168.50.0/24 subnet, and
you want to support up to 30 concurrent NetExtender sessions,
you could use 192.168.50.220 to 192.168.50.249, providing
they are not already in use.